Filter
Top Products
187
Controls in detail
Control system
Zone map South America
̈ Press button æ or ç to move
the selection marker to the
Vehicle
submenu.
̈ Press button j or k repeatedly
until the message
Compass setting
appears in the multifunction display.
The selection marker is on the current
setting.
̈ Press button æ or ç to set the
respective compass zone.
For information on how to call up the
compass, see “Compass” (
୴ page 342).
Compass calibration
This function is not available if your vehicle
is equipped with the COMAND system with
navigation module*.
In order to calibrate the compass properly,
mind the following:
ț Calibrate the compass in open terrain.
Nearby buildings, bridges, power lines
and large antenna masts, for example,
could impair compass calibration.
ț Switch off electrical consumers (e.g.
climate control, windshield wipers, or
rear window defroster).
ț Close all doors and the tailgate.
̈ Start the engine (୴ page 54).
̈ Press button æ or ç to move
the selection marker to the
Vehicle
submenu.
i
Make sure you are in an area where you can
drive a full circle with your vehicle without dis-
turbing traffic in order to calibrate your compass.
୴୴