Filter
Top Products
64
Getting started
Parking and locking
Switching off headlamps
̈ Turn the exterior lamp switch to M
(
୴ page 56).
For more information, see “Lighting”
(
୴ page 117).
Turning off engine
̈ Move the gear selector lever to park
position P.
Apply the parking brake (
୴ page 62).
̈ Turn SmartKey in the starter switch to
position 0.
̈ Remove the SmartKey from the starter
switch.
The immobilizer is activated.
Releasing seat belts
̈ Press seat belt release button
(
୴ page 50).
Allow the retractor to completely
rewind the seat belt by guiding latch
plate.
Warning! G
Do not turn off the engine before the vehicle
has come to a complete stop. With the
engine not running, there is no power assis-
tance for the brake and steering systems. In
this case, it is important to keep in mind that
a considerably higher degree of effort is
necessary to brake and steer the vehicle.
i
Always set the parking brake in addition to
shifting to park position P (୴ page 164).
On slopes, turn the front wheels towards the
road curb.
i
The SmartKey can only be removed from the
starter switch with the gear selector lever in park
position P and the SmartKey in starter switch
position 0.
!
Make sure the seat belt retracts fully so that
the seat belt and/or latch plate cannot get
caught or pinched in the door or in the seat
mechanism. This can damage the seat belt and
impair the effectiveness of the seat belt, and/or
cause damage to the door and/or door trim
panel. Such damage is not covered by the
Mercedes-Benz Limited Warranty.
Damaged seat belts must be replaced. Contact
an authorized Mercedes-Benz Light Truck
Center.