Filter
Top Products
491
Practical hints
Battery
3 Battery cover mounting nuts
̈ Using a 6 mm T-handle hex key (not
supplied with vehicle) with a minimum
shaft length of 12 in (30 cm), unfasten
and remove battery cover mounting
nuts 2 located at the floor carpet per-
foration.
̈ Move the front passenger seat to the
most forward position (
୴ page 43).
̈ Switch off the ignition (୴ page 38).
̈ Remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
̈ Make sure the vehicle’s on-board
electronics have status 0.
After turning off the engine with the
KEYLESS-GO start/stop button,
with the driver's door closed, the
starter switch is in position 1. With
the driver’s door opened, the start-
er switch is set to position 0, same
as SmartKey removed from starter
switch (
୴ page 39).
Step 3 (Disconnecting)
4 Seat rail, rear
5 Seat rail cover, rear
̈ Pull seat rail cover 5 away from seat
rail 4 on both sides as indicated by ar-
rows.
̈ Pull off seat rail cover 5 to the rear as
indicated by arrow.