Filter
Top Products
188
Controls in detail
Control system
̈ Drive a full circle at a vehicle speed of
between 3 mph and 6 mph (5 km/h
and 10 km/h).
When calibration was successful, the
following message appears in the mul-
tifunction display:
Compass Calibration
Completed Successfully
Setting which display to appear with
ignition switched off
This function lets you determine which dis-
play you would like to appear in the multi-
function display when you switch off the
ignition.
̈ Move the selection marker with
button æ or ç to the
Vehicle
submenu.
̈ Press button j or k repeatedly
until the message
Display when
ignition is switched off
appears in
the multifunction display.
The selection marker is on the current
setting.
̈ Press button æ or ç to select
the desired setting.
Setting automatic locking
Use this function to activate or deactivate
the automatic central locking. With the
automatic central locking system
activated, the vehicle is centrally locked at
vehicle speeds of approximately 9 mph
(15 km/h).
̈ Move the selection marker with
button æ or ç to the
Vehicle
submenu.
̈ Press button j or k repeatedly
until the message
Automatic door
lock
appears in the multifunction
display.
The selection marker is on the current
setting.
̈ Press button æ or ç to switch
the automatic central locking
on
or
off
.
i
If the message
Compass Calibration
Completed Successfully
does not ap-
pear in the multifunction display, drive
another full circle.
If calibration does not succeed within
3 minutes, the message
Compass Cal-
ibration
appears in the multifunction
display again. Calibrating the compass
has failed due to outside influences.
Repeat compass calibration in a differ-
ent location.
୴୴