Filter
Top Products
325
Controls in detail
Useful features
Reprogramming a single signal trans-
mitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
̈ Switch on the ignition (୴ page 38).
̈ Press and hold the desired signal
transmitter button (2, 3 or 4).
Do not release the button.
̈ The indicator lamp 1 will begin to
flash after 20 seconds. Without releas-
ing the signal transmitter button, pro-
ceed with programming starting with
step 3.
Operation of integrated remote control
̈ Switch on the ignition (୴ page 38).
̈ Select and press the appropriate inte-
grated signal transmitter button (2,
3 or 4) to activate the remote con-
trolled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
̈ Switch on the ignition (୴ page 38).
̈ Simultaneously press and hold down
the outer signal transmitter buttons 2
and 4, for approximately 20 seconds,
until the indicator lamp 1 flashes rap-
idly. Do not hold for longer than
30 seconds.
The codes of all three channels are
erased.
i
If you sell your vehicle, erase the codes
of all three channels.