Filter
Top Products
404
Practical hints
What to do if …
Lamps in instrument cluster General information:
If any of the following lamps in the instru-
ment cluster fails to come on during the
bulb self-check when switching on the
ignition, have the respective bulb checked
and replaced if necessary.
Problem Possible cause/consequence Suggested solution
- The yellow ABS indicator lamp
comes on while the engine is
running.
ABS has detected a malfunction and has
switched off. The BAS, ESP
®
, and 4-ETS are
also switched off (see messages in multifunc-
tion display).
The brake system is still functioning normally
but without the ABS available.
If the ABS control unit is malfunctioning,
other systems such as the navigation
system* or the automatic transmission may
also be malfunctioning.
̈ Continue driving with added caution.
Wheels may lock during hard braking,
reducing steering capability.
̈ Read and observe messages in the
multifunction display (
୴ page 416).
̈ Have the system checked at an
authorized Mercedes-Benz Light
Truck Center as soon as possible.
Failure to follow these instructions
increases the risk of an accident.
The charging voltage has fallen below
10 volts. The ABS has switched off.
The battery might not be charged sufficiently.
̈ Switch off electrical consumers that
are currently not needed, e.g. seat
heating*.
̈ If necessary, have the generator
(alternator) and battery checked.
When the voltage is above this value
again, the ABS is operational again.