Filter
Top Products
263
Controls in detail
Panorama roof with power tilt/sliding panel*
̈ Switch off the ignition (୴ page 38) and
remove the SmartKey from the starter
switch.
Vehicles with KEYLESS-GO*:
̈ Switch off the ignition (୴ page 39).
̈ Open the driver’s door (this puts the
starter switch in position 0, same as
with the SmartKey removed from the
starter switch). The driver’s door then
can be closed again.
̈ Remove the fuse securing the
tilt/sliding panel from the fuse box
(
୴ page 504).
̈ Reinsert the fuse in the fuse box.
̈ Switch on the ignition (୴ page 38).
̈ Push and hold the roof panel switch in
direction of arrow 2 (
୴ page 260) un-
til the roller sunblinds are fully closed.
̈ Keep holding the roof panel switch in
direction of arrow 2 (
୴ page 260) for
approximately 1 second.
̈ Pull and hold the roof panel switch in
direction of arrow 1 (
୴ page 260) un-
til the roller sunblinds are fully opened.
̈ Keep holding the roof panel switch in
direction of arrow 1 (
୴ page 260) for
approximately 1 second.
̈ Press and hold the roof panel switch in
direction of arrow 3 (
୴ page 260) un-
til the tilt/sliding panel is fully raised at
the rear.
̈ Push and hold the roof panel switch in
direction of arrow 2 (
୴ page 260) un-
til the tilt/sliding panel is fully closed.
̈ Keep holding the roof panel switch in
direction of arrow 2 (
୴ page 260) for
approximately 1 second.
̈ Open the tilt/sliding panel using the
Express-open feature (
୴ page 262).
If the tilt/sliding panel opens com-
pletely, the roof is synchronized.
If the tilt/sliding sunroof does not open
completely:
̈ Repeat the above steps.
i
For information on which fuse box con-
tains the fuse for the power tilt/sliding
panel, see the fuse chart provided with
the vehicle tool kit (
୴ page 455).