Filter
Top Products
59
Getting started
Parking and locking
Releasing seat belts
̈ Press the seat belt release button
(
୴ page 46).
Allow the retractor to completely re-
wind the seat belt by guiding the latch
plate.
Locking
!
If you hear a warning signal, you have
probably tried to turn off the engine
without the gear selector lever in P.
Place the gear selector lever in P.
!
Make sure the seat belt retracts fully so
that the seat belt and/or latch plate
cannot get caught or pinched in the
door or in the seat mechanism. This
can damage the seat belt and impair
the effectiveness of the seat belt,
and/or cause damage to the door
and/or door trim panel. Such damage
is not covered by the Mercedes-Benz
Limit Warranty.
Damaged seat belts must be replaced.
Contact an authorized Mercedes-Benz
Center.
Warning! G
To prevent possible personal injury, always
keep hands and fingers away from the door
openings when closing the doors. Be espe-
cially careful when small children are
around.
Before closing doors, make sure there is no
possibility of someone getting caught in a
door during closing.
Warning! G
When leaving the vehicle, always remove the
SmartKey or SmartKey with KEYLESS-GO*
from the starter switch, take it with you, and
lock the vehicle. Do not leave children unat-
tended in the vehicle, or with access to an
unlocked vehicle. Unsupervised use of vehi-
cle equipment may cause an accident
and/or serious personal injury.
i
Opening a door causes the windows on
that side of the car to open slightly.
They will return to the up position when
the door is closed.
i
A warning sounds and the message
Turn off lamps
appears in the multi-
function display if the vehicle’s exterior
lamps are not switched off
ț with the SmartKey removed from
the starter switch and