Filter
Top Products
248
Controls in detail
Power windows
Fully closing the door windows
(Express-close)
̈ Pull switch 1 or 2 past the
resistance point and release.
The corresponding window closes
completely.
Stopping windows during
Express-operation
̈ Press or pull the respective power win-
dow switch again.
Synchronizing power windows
The power windows must be resynchro-
nized each time
ț after the battery has been
disconnected.
ț if the power windows cannot be fully
opened (Express-open) or closed
(Express-close).
̈ Switch on the ignition (୴ page 36).
̈ Pull the power window switches until
the side windows are closed.
̈ Hold the switches for approximately
one second.
The power windows are synchronized.
!
If the upward movement of a door win-
dow is blocked during the closing pro-
cedure, the door window will stop and
open slightly.
Remove the obstruction, pull the
switch again past the resistance point
and release.
If the door window still does not close
when there is no obstruction, then pull
the switch and hold it. The door window
will then close without the obstruction
sensor function.
Warning! G
Driver’s door only:
If within five seconds you again pull the
switch past the resistance point and re-
lease, the automatic reversal will not
function.