Filter
Top Products
288
Controls in detail
Useful features
Programming the integrated remote
control
Step 1:
̈ Switch on the ignition (୴ page 36).
Step 2:
̈ If you have previously programmed a
signal transmitter button and wish to
retain its programming, proceed to
step 3.
If you are programming the integrated
remote control for the first time, press
and hold the two outer signal transmit-
ter buttons 2 and 4 and release
them only when the indicator lamp 1
begins to flash after approximately
20 seconds (do not hold the button for
longer than 30 seconds). This proce-
dure erases any previous settings for
all three channels and initializes the
memory.
If you later wish to program a second
and/or third hand-held transmitter to
the remaining two signal transmitter
buttons, do not repeat this step and be-
gin directly with step 3.
Step 3:
̈ Hold the end of the hand-held remote
control 5 of the device you wish to
train approximately 2 to 5 in
(5 to12 cm) away from the signal trans-
mitter button (2, 3 or 4) to be pro-
grammed, while keeping the indicator
lamp 1 in view.
Step 4:
̈ Using both hands, simultaneously
press the hand-held remote control
button 6 and the desired signal trans-
mitter button (2, 3 or 4). Do not
release the buttons until step 5 is com-
pleted.
The indicator lamp 1 will flash, first
slowly and then rapidly.
Step 5:
̈ After the indicator lamp 1 changes
from a slow to a rapidly flashing light,
release the hand-held remote control
button and the signal transmitter but-
ton.
Step 6:
̈ Press and hold the just-trained signal
transmitter button (2, 3 or 4) and
observe the indicator lamp 1.
When programming a garage door opener,
park the vehicle outside the garage.
Do not run the engine while programming
the integrated remote control. Inhalation of
exhaust gas is hazardous to your health. All
exhaust gas contains carbon monoxide
(CO), and inhaling it can cause unconscious-
ness and possible death.
i
The indicator lamp 1 flashes immedi-
ately the first time the signal transmit-
ter button is programmed. If this button
has already been programmed, the in-
dicator lamp will only start flashing af-
ter 20 seconds.
୴୴