Open as PDF
MAINTENANCE WORK ON CHASSIS AND ENGINE 46
Greasing the steering head bearingbx
Remove the lower triple clamp. ( P. 43)
Install the lower triple clamp. ( P. 44)
(EXC-RbEU, EXC-RbAUS/UK, EXC-RbUSA, XCR-WbZA)
Remove the lower triple clamp. ( P. 44)
Install the lower triple clamp. ( P. 45)
Dismounting the front fender
ದ Remove screwsb. Remove the front fender.
ದ Make sure that the distance bushings remain in place.
Installing the front fender
ದ Check parts for damage and wear. Replace damaged or worn parts.
ದ Make sure that the distance bushings are mounted in the fender.
ದ Position the front fender. Mount and tighten screwsb
Remaining screws, chassis M6 10bNm (7.4blbfbft)
Ensure that there is contact between the holding lugs and the start number
plate or headlight mask.
Removing headlight mask with headlight (EXC-RbEU, EXC-RbAUS/UK, EXC-RbSIXbDAYS, EXC-RbUSA, XCR-WbZA)
ದ Switch off all electrical equipment.
ದ Remove screwb
and take off clamp.
ದ Loosen the rubber bandb
. Push up the headlight mask and swing it forwards.
ದ Pull out the electric plug connectorb and remove the headlight mask with the