Filter
Top Products
MAINTENANCE WORK ON CHASSIS AND ENGINE 48
500209-11
ಥ Operate the hand brake lever repeatedly until the brake linings lie on the brake disc
and there is a tight spot.
ಥ Remove the motorcycle from the work stand. ( P. 21)
ಥ Pull the front wheel brake and push down hard on the fork several times to align
the fork legs.
ಥ Fully tighten screw
.
Specification
Screw, fork stub M8 15Nm
(11.06lbfft)
Removing rear wheelx
ಥ Jack up the motorcycle. ( P. 21)
500213-10
ಥ Press the brake caliper by hand on to the brake disc in order to press back the
brake piston.
Info
Make sure when pushing back the brake piston that you do not press the
brake caliper against the spokes.
ಥ Remove nut.
ಥ Remove chain adjuster
. Withdraw the wheel spindle only enough to allow the
rear wheel to be pushed forward.
ಥ Push the rear wheel forward as far as possible. Remove the chain from the rear
sprocket.
ಥ Holding the rear wheel, withdraw the wheel spindle. Take the rear wheel out of the
swing arm.
Info
Do not operate the foot brake when the rear wheel is removed.
Always lay the wheel down in such a way that the brake disc is not dam-
aged.
500214-11
ಥ Remove the spacing sleeves.
Fitting rear wheelx
Warning
Danger of accidentsಗReduced braking due to oil or grease on the brake discs.
ಥ Always keep the brake discs free of oil and grease, and clean them with brake cleaner when necessary.
500214-10
ಥ Check parts for damage and wear. Replace damaged or worn parts.
ಥ Clean and grease shaft seal rings
and bearing surface of the spacing sleeves.
Long-life grease ( P. 84)
ಥ Fit the spacing sleeves.