Filter
Top Products
00AA
MAINTENANCE WORK ON CHASSIS AND ENGINE 38
Adjusting chain guidex
500194-10
ಥ Remove screws and. Take off the chain guide.
Conditions
Number of teeth: 싨44teeth
ಥ Insert nut
in hole. Position the chain guide.
ಥ Mount and tighten screws
and.
Specification
Remaining screws, chassis M6 10Nm
(7.38lbfft)
Conditions
Number of teeth: 싩45teeth
ಥ Insert nut
in hole. Position the chain guide.
ಥ Mount and tighten screws
and.
Specification
Remaining screws, chassis M6 10Nm
(7.38lbfft)
Brake fluid reservoir
Warning
Danger of accidentsಗBrake system failure.
ಥ If the brake fluid level falls below the MIN mark, this indicates a leakage in the brake system or worn-out brake linings.
Have the brake system checked in an authorized KTM workshop, and do not ride any further.
The brake fluid reservoirs of the front and rear brakes are dimensioned so that they do not need topping up with brake fluid even if the
brake linings are worn.
Brake calipers
The brake calipers of this series are "floating", which means that they are not fixed to the brake caliper support.
The lateral compensation ensures an optimal position of the brake pad in relation to the brake disc.
Checking brake discs
Warning
Danger of accidentsಗReduced braking due to worn brake discs.
ಥ Worn brake discs should be replaced immediately by an authorized KTM workshop.
400388-10
ಥ Check the thickness of the front and rear brake discs at several places on the disc
to see if it conforms to measurement
.
Info
Wear reduces the thickness of the brake disc around the area used by the
brake linings.
Wear limit of brake discs
front 4.5mm (0.18in)
Rear 3.5mm (0.14in)
» The brake disc thickness is less than the specified value.
ಥ Replace the brake disc.