Filter
Top Products
MAINTENANCE WORK ON CHASSIS AND ENGINE 49
9.31Greasing the steering head bearing x
800010-10
–
Remove the lower triple clamp. x ( p. 47)
–
Install the lower triple clamp. x ( p. 48)
9.32Removing the front fender
600692-10
– Remove screws . Remove the front fender.
– Make sure the spacers remain in place.
9.33Installing the front fender
600692-10
– Ensure that the spacers are mounted in the fender.
– Position the front fender. Mount and tighten screws .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Info
Make sure the holding lugs engage in the start number plate or headlight
mask.
9.34Removing headlight mask with headlight
600703-10
– Switch off all electrical equipment.
– Remove screw and take off clamp.
– Loosen the rubber band . Push up the headlight mask and swing it forwards.
600702-10
– Pull out the electric plug connector and remove the headlight mask with the
headlight.