Filter
Top Products
MAINTENANCE WORK ON CHASSIS AND ENGINE 70
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use
3 months
– Mount the seat. ( p. 71)
9.74Removing a fuse
– Switch off all consumers and the engine.
– Remove the air filter box lid. ( p. 76)
400270-10
– Remove protective cover .
Info
The fuse is located in the starter relay under the filter box cover.
– Remove the fuse .
9.75Installing the fuse
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect fuses.
– Use only fuses with the prescribed amperage. Never by-pass or repair fuses.
400273-10
– Insert the fuse.
Fuse (58011109110)
Info
A reserve fuse is located in the starter relay.
Replace a blown fuse only by an equivalent fuse.
– Replace the protection cover.
– Install the air filter box lid. ( p. 76)
9.76Checking the headlight adjustment
0
0
AA
0
0
BB
400726-10
– On a light-colored wall behind a horizontal area, make a mark as high as the center
of the headlight.
– Make a second mark at distance of under the first mark.
Guideline
Distance 5 cm (2 in)
– Stand the motorcycle upright in front of the wall at distance . The driver, in full
protective clothing, should now sit on the motorcycle in a normal sitting position
(feet on the footrests).
Guideline
Distance 5 m (16 ft)
– Switch on low beam. Check the headlight adjustment.
The border between light and dark must be exactly at the lower mark when the
motorcycle is operational and complete with rider.
» If the boundary between light and dark does not meet specifications:
– Adjust the beam width of the headlight. ( p. 71)