Filter
Top Products
SKY CMD – 3
PROGRAMMING CALL SIGNS
The built-in TNCs of the Commander and Transporter
communicate each other when you send a control
command from the Commander. So you must program
different call signs (9 digits max.) on these transceivers as
the IDs of the TNCs.
Use the following Menu Nos. to program call signs:
On Commander
500 COM Callsign Call sign for Commander
501 TRP Callsign Call sign for Transporter
On Transporter
500 COM Callsign Call sign for Commander
501 TRP Callsign Call sign for Transporter
1 Access Menu 500 or 501, then [ (OK)].
•The callsign entry field appears; the first digit blinks.
2 Press [ ]/[ ] or rotate the Tuning control to select a
character.
• You can enter 0 to 9, A to Z, and –.
3 Press [ OK].
• The cursor moves to the next digit.
4 Repeat steps 2 and 3 to enter up to 9 digits.
[ESC ]: Cancels entry of a call sign.
[A/B]: Deletes the digit at which the cursor is blinking.
5 Press [ OK]. to complete the setting.
6 Press [MENU] to exit Menu mode.
The keypad also is available to enter alphanumeric
characters in step 2.
PROGRAMMING A TONE FREQUENCY
On receiving a tone from the Commander, the Transporter
causes the HF transceiver to enter Transmit mode. On
both the Commander and Transporter, access Menu 502
and select the desired, same tone frequency.
CONTROL OPERATION
When in the Sky Command mode, the Microphone keys
of the Commander will function as below. First switch
ON the HF transceiver and press Microphone [0] on the
Commander.
Each time you press the desired key, the Commander
will automatically enter transmit mode and send the
corresponding control command to the Transporter.
Key Function
Tuning
control
Frequency or memory channel number
change
[1] (PWR) Power ON/ OFF
[2] (RX) HF frequency receive ON/ OFF
[3] (MODE) Modulation mode switch
[4] (RIT)
RIT ON/ OFF
[5] (XIT)
XIT ON/ OFF
[6] (CLR)
RIT offset or XIT offset clear
[7] (SPLIT)
Split-frequency ON/ OFF
[8] (M>V)
Transfer from Memory to VFO
[9] (A/B)
In VFO mode: VFO A/ VFO B switch
In Memory Recall mode: no change
[0] (SYNC)
Current settings retrieve (from HF
transceiver)
[MONI]
To monitor the UHF band on the
Commander
[B] (M/V)
VFO/ Memory Recall mode switch
[ ]
XIT/ RIT offset frequency increase
[ ]
XIT/ RIT offset frequency decrease
[ ]
1
(FAST)
In LSB, USB, or CW mode: 10 Hz/ 1 kHz
switch
In FM or AM mode: 1 kHz/ 10 kHz switch
[#]
2
(ENTER)
In VFO mode: frequency entry ON
In Memory Recall mode: channel number
entry ON
[PTT]
To transmit audio on an HF frequency
1
“FS” appears when you select 1 kHz step (LSB/ USB/ CW) or 10 kHz
step (FM/ AM).
2
After pressing [#], press [0] to [9] to enter a frequency or memory
channel number.
Tuning control