Filter
Top Products
PACKET – 4
Command Name Short Description Parameter Default
LOCATION LOC
If set to EVERY, sends GPS data at intervals of the
specified period (n). If set to AFTER, sends GPS data
only once after the specified period (n). The unit of n
is 10 seconds.
EVERY/ AFTER
n
(n = 0 ~ 250)
EVERY 0
LPATH LPA
Specifies call signs to send GPS data. Call1 is the call
sign of the destination. Call2 to call8 are call signs of
stations to be digipeated through.
Call (VIA call1,
call2, ... call8)
GPS
LTEXT LT
Specifies the content of a message to be included in
GPS data.
0 ~ 159
characters
ï
LTMON LTM
Specifies the interval for displaying a message
determined by LTEXT on the screen; a message
appears like a received beacon packet. The unit of the
parameter is 1 second.
0 ~ 250 0
MAIL MAI
When ON and the TNC mailbox holds a message
addressed to you, outputs “Low” to the MAILLED
terminal.
ON/ OFF OFF
MAXFRAME MAX
Specifies the maximum number of packets to be
transmitted at one time.
11
MCOM MCOM
When ON, causes the TNC to also monitor control
packets. When OFF, causes it to monitor only
information packets.
ON/ OFF OFF
MCON MC
When ON, causes the TNC to monitor other stations
while in connection with the target station.
ON/ OFF OFF
MINE MI
Displays the list of messages, in the TNC mailbox,
addressed to you and messages that you sent.
ïï
MONITOR M When ON, causes the TNC to monitor packets. ON/ OFF ON
MRPT MR
When ON, causes the TNC to display the entire
digipeat list for monitored packets.
ON/ OFF ON
MSTAMP MS
When ON, causes the TNC to display data and time
information for monitored packets.
ON/ OFF OFF
MYALIAS MYA
Specifies a call sign for using your station as a
digipeater.
6 characters +
SSID
ï
MYCALL MY Specifies your call sign.
6 characters +
SSID
ï
MYMCALL MYM
Specifies a call sign to be assigned to your TNC
mailbox.
6 characters +
SSID
ï
NEWMODE NE
When ON, entering a CONNECT command causes
the TNC to immediately enter the other mode.
ON/ OFF OFF
NOMODE NO
When ON, does not cause the TNC to automatically
enter the other mode. When OFF, causes it to
automatically enter the other mode as specified by
NEWMODE.
ON/ OFF OFF
NPATH NPATH
Specifies digipeater call signs to be added when the
UISSID parameter in a received packet is 8 or 12.
Call1, ... call7
ï
NTSGRP NTSGRP
Specifies a group code to be used for making a
$PNTS sentence.
0 ~ 3 characters
ï
NTSMRK NTSMRK
Specifies a mark number to be used for making a
$PNTS sentence.
0 ~ 14 0
NTSMSG NTSMSG
Specifies a message to be used for making a $PNTS
sentence.
0 ~ 20 characters
ï
PACLEN P
Specifies the maximum length of the data portion of a
packet.
0 ~ 255 128