Filter
Top Products
MEMORY CH – 2
STORING ODD-SPLIT REPEATER FREQUENCIES
Some repeaters use a receive and transmit frequency pair
with a non-standard offset. To access those repeaters,
store two separate frequencies in a memory channel. You
can then operate on those repeaters without changing the
offset frequency you stored in the menu.
1 Set up a simplex channel by following steps 1 to 6 of
“STORING SIMPLEX AND STANDARD REPEATER
FREQUENCIES”, above.
2 Press [VFO] to enter VFO mode.
3 Press [
]/[ ] or rotate the Tuning control to select
your desired transmit frequency.
4 Set up any additional data desired for the transmit
frequency.
• Tone On/Off, Tone frequency, CTCSS On/Off,, CTCSS
frequency, DCS On/Off, DCS code, etc.
5 Press [F].
• A memory channel number appears.
6 Press [ ]/[ ] or rotate the Tuning control to select
your desired channel number.
7 Press [ OK] while pressing [PTT] to store the data in
the selected Memory channel.
Q Call Channel Memory (Odd-Split)
The Call channel can be used to store any frequency
and related data that you will recall often. You may
want to dedicate the Call channel as an emergency
channel within your group.
To store an odd-split frequency and related data as the
Call channel instead of in a Memory channel, after step
6 (above), press [CALL] while pressing [PTT].
Note:
X You cannot set the transmission and reception frequencies on
different bands.
X You cannot set a different frequency step size for the
transmission and reception frequencies.
X You cannot store the transmit offset status and Reverse status in
an odd-split Call channel.
RECALLING A MEMORY CHANNEL
1 Press [MR] to enter Memory Recall mode.
2 Press [ ]/[ ] or rotate the Tuning control to select
your desired Memory channel.
• Additionally, you can enter a channel number using the
keypad.
Q Memory Recall Method
The transceiver Menu also provides you with the option
to recall Memory channels with stored frequencies in
your current band, or all Memory channels:
1 Enter Menu mode and access Menu 143.
2 Set the recall method to “Current band” or “All
bands”.
• “Current band” allows you to recall only those memory
channels that have stored frequencies within the
current band. “All bands” allows you to recall all
programmed memory channels.
• When the recalled memory channel is an AM channel,
you cannot recall on the A band.
RECALLING A CALL CHANNEL
1 Press [CALL] to enter Call Channel mode.
• “C” appears on the display.
• If the frequency of the operating band is less than 300
MHz, the VHF CALL channel is used for recall. If the
frequency is over 300 MHz, the UHF CALL channel is
used for recall.
2 Press [CALL] again, the transceiver will return to the
previous status (VFO mode or Memory Channel mode)
before entering CALL mode.
CLEARING A MEMORY CHANNEL
1 Press [MR] to enter Memory Recall mode.
2 Turn the transceiver power Off.
3 Press [MR] + Power ON to enter Memory Channel
Clear mode.
4 Press [ ]/[ ] or rotate the Tuning control to select
your desired Memory channel.
5 Press [ OK].
• “Sure?” appears on the display and blinks.
6 Press [ OK] or [MR] to clear the Memory channel.
• Repeat steps 4 to 6 to clear additional Memory channels.
• To exit without clearing the channel, press [ESC
].