Filter
Top Products
CTCSS/ DCS/ CROSS TONE – 3
DCS CODE SCAN
This function scans through all DCS codes to identify the
incoming DCS code on a received signal. You may find it
useful when you cannot recall the DCS code that the other
persons in your group are using.
1 Press [TONE] 3 times to activate the DCS function.
• The “ ” icon appears on the display when the DCS
function is on.
• Each time you press
[TONE], the selection changes as
follows:
Tone (
) ° CTCSS ( ) ° DCS ( ) ° Cross
Tone (
: default) ° Off (no display).
<Additionally, when APRS is ON and Voice Alert is
configured, Voice Alert ON is added to the above cycle.>
2 Press [F], [TONE] (1s).
• Scan starts and “Scanning” blinks on the display.
• To quit the scan, press [ESC ].
• When a DCS code is identified, the identified code
appears on the display and blinks.
3 Press [ OK] to program the identified code in place of
the currently set DCS code.
• The DCS function will remain on. To cancel DCS, press
[TONE] until DCS no longer appears on the display.
• Press [ESC
] if you do not want to program the
identified code.
CROSS TONE
USING CROSS TONE
You can set separate signaling types by TX and RX for
when you access a repeater that uses different Encode/
decode signaling.
To turn the Cross Tone function On:
Press [TONE] 4 times to activate the Cross Tone function.
• The “ ” (default) icon appears on the display when the
Cross Tone function is On.
• Each time you press [TONE], the selection changes as
follows:
Tone (
) ° CTCSS ( ) ° DCS ( ) ° Cross Tone (
: default) ° Off (no display).
<Additionally, when APRS is ON and Voice Alert is
configured, Voice Alert ON is added to the above cycle.>
Q Selecting a Cross Tone mode
To select the cross tone/code frequency required to
access your desired repeater:
1 Turn the Cross Tone function On.
2 Press [F], [TONE].
• The Cross Tone setting appears on the display.
3 Press [ ]/[ ] or rotate the Tuning control to select
your desired Cross Tone setting.
Setting Encode Decode Icon
DCS/Off DCS off
TONE/DCS Tone DCS
DCS/CTCSS DCS CTCSS
TONE/CTCSS Tone CTCSS
• To exit the Cross Tone setting selection, press
[ESC
].
4 Press [ OK] to set the selected setting.