Filter
Top Products
GPS – 3
SWhen set to “GPS Only”, you can operate only the
following key functions.
Key
Name
[KEY] [F], [KEY] [KEY] (1s)
[KEY] +
Power ON
[LAMP]
Lamp
Continuous
Lamp On
Lamp –
[ ]
[
]
[
OK]
[ESC
]
–
Function/
Menu select
––
[MENU]
Menu
mode
RF power
select
––
[A/B]
––––
[1]
MARK
Internal
GPS On/Off
Register
mode
of Mark
Waypoint
–
[2]
–
Starting
the LOG
function
––
[3]
POS – – –
[F]
Function
mode
– – Reset mode
Q Battery Saver (GPS Save)
This function will turn the GPS power source Off
after the programmed timer expires if position data
is not determined during the maximum catching time
(approximately 5 minutes). To prevent unnecessary
battery consumption, when there are many reception
satellites, the GPS is stabilized and position data can
be determined, the GPS power source repeatedly turns
On and Off.
1 Enter Menu mode and access Menu 201.
2 Set GPS Off time to “Off”, 1, 2, 4, 8, or “Auto”.
Auto: When set to Auto, the GPS Off time starts
at 1 minute for the first time, then progresses to 2
minutes, 4 minutes and 8 minutes each additional time.
The GPS Off time remains at 8 minutes thereafter.
However, after having determined your position for the
duration, if the GPS cannot pinpoint your location, the
GPS Off time will restart at 1 minute.
Note:
X Position precision may be improved by setting the Batter
Saver (GPS Save) function to “Off”.
X You cannot set the SBAS function to “On” when the Batter
Saver (GPS Save) function is 1, 2, 4, 8, or Auto. Set the
Battery Saver (GPS Save) function to “Off”.
Q GPS Data PC Output
Turn this function on when you want to send the
Internal GPS receiver data (NMEA) from the PC
terminal using.
1 Enter Menu mode and access Menu 202.
2 Set PC Output to “Off” or “On”.
GPS DATA SETUP
Q Land Survey System Datum
When using the Internal GPS receiver, set up the
necessary land surveying system.
For APRS, select “WGS-84” (world land surveying
system).
1 Enter Menu mode and access Menu 210.
2 Set Datum to “WGS-84”.
• This function does not work when using an external
GPS receiver.
Q Sentence
Adds an NMEA sentence to the Internal GPS receiver
data output from the PC.
1 Enter Menu mode and access Menu 211.
2 Set Sentence to “$GPGGA”, “$GPGLL”, “$GPGSA”,
“$GPGSV”, “$GPRMC”, “$GPVTG”, or $GPZDA”.
• With BEACON transmission, the “$GPGGA”
“$GPRMC” check (
) cannot be removed in
necessary information and satellite image information.
• You cannot output an NMEA sentence from an
external GPS receiver to a PC.