Filter
Top Products
CTCSS/ DCS/ CROSS TONE – 2
CTCSS FREQUENCY SCAN
This function scans through all CTCSS frequencies to
identify the incoming CTCSS frequency on a received
signal. You may find this useful when you cannot recall
the CTCSS frequency that the other persons in your group
are using.
1 Press [TONE] 2 times to activate the CTCSS function.
• The “ ” icon appears on the display when the CTCSS
function is On.
• Each time you press
[TONE], the selection changes as
follows:
Tone (
) ° CTCSS ( ) ° DCS ( ) ° Cross
Tone (
: default) ° Off (no display).
<Additionally, when APRS is ON and Voice Alert is
configured, Voice Alert ON is added to the above cycle.>
2 Press [F], [TONE] (1s).
• Scan starts and “Scanning” blinks on the display.
• To quit the scan, press [ESC ].
• When a CTCSS frequency is identified, the identified
frequency appears on the display and blinks.
3 Press [Ź (OK)] to program the identified frequency in
place of the currently set CTCSS frequency.
• The CTCSS function will remain on. To cancel CTCSS,
press [TONE] until CT no longer appears on the display.
• Press
[ESC
] if you do not want to program the
identified frequency.
DCS
USING DCS
1 Select your desired band.
2 Press [TONE] 3 times to activate the DCS function.
• The “ ” icon appears on the display when the DCS
function is on.
• Each time you press [TONE], the selection changes as
follows:
Tone (
) ° CTCSS ( ) ° DCS ( ) ° Cross
Tone (
: default) ° Off (no display).
<Additionally, when APRS is ON and Voice Alert is
configured, Voice Alert ON is added to the above cycle.>
3 Press [F], [TONE].
• The current DCS code appears on the display and blinks.
4 Press [ ]/[ ] or rotate the Tuning control to select
your desired DCS code.
• Refer to the table below for the available codes.
• To exit the DCS code selection, press
[ESC
].
5 Press [ OK] to complete the setting.
6 When you are called: The transceiver squelch opens
only when the selected DCS code is received.
When you make a call: Press and hold [PTT], then
speak into the microphone.
• To cancel DCS, press [TONE] until DCS no longer
appears on the display.
DCS Code
023 025 026 031 032 036 043 047
051 053 054 065 071 072 073 074
114 115 116 122 125 131 132 134
143 145 152 155 156 162 165 172
174 205 212 223 225 226 243 244
245 246 251 252 255 261 263 265
266 271 274 306 311 315 325 331
332 343 346 351 356 364 365 371
411 412 413 423 431 432 445 446
452 454 455 462 464 465 466 503
506 516 523 526 532 546 565 606
612 624 627 631 632 654 662 664
703 712 723 731 732 734 743 754