Filter
Top Products
APRS – 14
Q QSY Transmission Operation
1 Access Menu 3A0.
2 Set it to “On”.
3 Access Menu 3A1.
4 Set it to “On” or “Off”.
5 Access Menu 3A2.
6 Set it to “On” or “Off”.
Q Operation when Receiving a QSY
When QSY (frequency) information is received, the
station list appears with the verified frequency. Select
[Tune], then press [ OK].
• The QSY (frequency) is set to the non data band.
Note: When using 6.5 kHz or 12.5 kHz step values, the display
does not indicate values for 100 Hz and lower.
SETTING PACKET FILTER
Q Position Limit
Access Menu 3B0.
If APRS is popular in your area, you may receive too
many APRS packets for a short period. If this disturbs
your APRS activities, specify a distance from your
location. You will not receive APRS packets from
stations beyond this distance.
Select the range from 10 to 2500 in steps of 10, plus
OFF (default). The unit is mile or kilometer depending
on the selection in Menu 3V0 (Units 1).
Q Packet Filter Type
1 Access Menu 3B1.
2 Select the Filter type to “Weather”, “Digipeater”,
“Mobile”, “Object”, “Navitra”, “1-WAY”,or“Others”.
3 Press [
OK].
• When you press [MHz], the “ ” icon appears on the
left side of the Filter type.
The APRS position data is filtered.
• Check the type(s) you want to receive.
• If all types are checked, you will receive all types of data.