Filter
Top Products
GPS – 5
LOG SETUP
Q Track Log Acquisition Type
You can set the conditions for saving portable Track
information as GPS Logger.
You can change the settings for travel speed, etc.
1 Enter Menu mode and access Menu 230.
2 Select “Time”, “Distance”, or “Beacon” for the
Record Method.
3 Access Menu 231.
4 Select an Interval time from 2 ~ 1800 seconds (in
steps of 1 second).
• The Interval setting is available only if the Record
Method has been set to “Time”.
5 Access Menu 232.
6 Select a Distance from 0.01 ~ 9.99 (in steps of
0.01).
• The Distance setting is available only if the Record
Method has been set to “Distance”.
• The unites used for Distance can be set to miles (mi),
kilometers (km) or nautical miles (nm).
Interval and Log Total Time:
Point
Q'ty
Interval time (second)
2 5 10 15 30 2800
5000
166.7 41.7 833.3 1250 2500
150000
(min)
2.8 6.9 13.9 20.8 28
2500
(hour)
Interval and Total Distance:
Point
Q'ty
Interval distance (km)
0.01 2.00 4.00 6.00 8.00 9.99
5000 50 10000 20000 30000 40000
49950
(km)
TARGET POINT
You can register positional information for a target point.
1 Enter Menu mode and access Menu 240.
2 Select a Target Point (from 1 ~ 5).
3 Press [MHz]. The “in use” target point mark ( )
appears to the left of the channel number.
4 Access Menu 241.
5 Enter a Target Point name (up to 8 characters).
6 Access Menu 242.
<Menu No. 3W0: “dd°mm.mm’ ”>
<Menu 3W0: “dd°mm’ss.s” ”>
7 Enter the north/ south latitude.
8 Access Menu 243.
<Menu No. 3W0: “dd°mm.mm’ ”>
<Menu 3W0: “dd°mm’ss.s” ”>
9 Enter the east/ west longitude.