Filter
Top Products
8
English
Getting Started
Unpacking
After unpacking, check to be sure that you have all the
following items.
The number in parentheses indicates the quantity of each
piece supplied.
• FM antenna (1)
• AM loop antenna (1)
• Remote control (1)
• Batteries (2)
• Video cord (1)
• Speaker cords (2)
If any item is missing, consult your dealer immediately.
Putting the Batteries into the Remote
Control
Insert the batteries—R6P(SUM-3)/AA(15F)—into the
remote control by matching the polarity (+ and –) on the
batteries with the + and – marking on the battery
compartment.
When the remote control can no longer operate the unit,
replace both batteries at the same time.
• DO NOT use an old battery together with a new
one.
• DO NOT use different types of batteries together.
• DO NOT expose batteries to heat or flame.
• DO NOT leave the batteries in the battery
compartment when you are not going to use the
remote control for an extended period of time.
Otherwise, the remote control will be damaged
from battery leakage.
1
2
3
R6P(SUM-3)/AA(15F)
FM
(75 )
COAXIAL
AM
LOOP
ANTENNA
AM
EXT
FM antenna (supplied)
Connecting Antennas
FM antenna
1
Attach the FM antenna to the FM (75 Ω) COAXIAL
terminal.
2
Extend the FM antenna.
3
Fasten it up in the position which gives you the best
reception.
About the supplied FM antenna
The FM antenna supplied with this unit can be used as temporary
measure. If reception is poor, you can connect an outdoor FM
antenna.
To connect an outdoor FM antenna
Before connecting it, disconnect the supplied FM antenna.
FM
(75 )
COAXIAL
AM
LOOP
ANTENNA
AM
EXT
A 75 Ω antenna with coaxial type connector
(IEC or DIN 45325) should be used.
Outdoor FM antenna
(not supplied)
Continued
EN08_17UX-A10DVD[UB].pm6 02.10.7, 8:08 AM8