JVC UX-A10DVD Automobile Alarm User Manual


 
28
English
Good
No good
Disc tray
Electronic swing
panel
IMPORTANT:
Before performing any operations for DVD, SVCD and
VCD, make sure of the following.
Check the connection with the TV.
Turn on the TV and select the correct input on the TV to
view the pictures or on-screen menus/indications on the
TV screen.
Select the correct color system.
To prevent screen burn-out with the screen saver
A TV screen may be burned out if a static picture is
displayed for a long time. To prevent this, the unit
automatically dims the screen if a static picture is
displayed for over 5 minutes (the screen saver function).
Pressing any button will cancel the screen saver
function.
You can select the screen saver mode. (See page 86.)
The screen saver does not work for Audio CDs and
MP3 discs.
On-screen guide icons
During DVD playback, the following guide icons may
appear for a while on the TV screen:
–“ ” : appears at the beginning of a scene
containing multi-angle views.
–“ ” : appears at the beginning of a scene
containing multi-audio languages.
–“
” : appears at the beginning of a scene
containing multi-subtitle languages.
•“ ” (Play), “ ” (Pause), “ ”/“ ” (Fast
forward/backward), “
”/“ ” (Slow-motion
forward/backward): appears when you perform each
operation.
If “
” appears on the TV screen when pressing
a button, the disc cannot accept an operation you
have tried to do, or information required for that
operation is not recorded on the disc.
More about the on-screen guide icons
In some cases, without showing “ ,” operations will not
be accepted.
If you do not want the on-screen guide icons to appear, see
page 86.
The disc indicator rotates while a disc is being played.
The disc indicator goes off when there is no disc in the disc tray.
Loading a Disc
Available for:
DVD
DVD
SVCD
SVCD
VCD
VCD
Anduio CD
Audio CD
MP3
MP3
1
Press DVD 0 on the main unit.
The unit automatically turns on, the electronic swing
panel slides downward, then the disc tray comes out.
2
Place a disc correctly on the circle of the disc tray
with its label side up.
When using an 8 cm disc, place it on the inner circle
of the disc tray.
3
Press DVD 0.
The disc tray closes, then the electronic swing panel
slides upward automatically.
If you press DVD #/8 on the main unit (or DVD
SELECT 3 on the remote control) instead of DVD
0, the disc tray and electronic swing panel closes,
then playback starts.
To remove the disc, press DVD 0.
After removing the disc, press DVD 0 again to close the
disc tray.
When you use the Resume function (see page 86),
pressing DVD 0 erases the memory of the position
where you have stopped playback.
About the disc indicators
When a DVD
is loaded.
When a VCD or
SVCD is loaded.
When an Audio CD
or MP3 disc is
loaded.
EN27_39UX-A10DVD[UB].pm6 02.10.7, 8:09 AM28