Jaguar XJ Automobile User Manual


 
R
(FM8) SEMCON JLR OWNER GUIDE VER 1.00 NAS
LANGUAGE: english-NAS-en; MARQUE: jaguar; MODEL: XJ
Luggage compartment
73
Luggage compartment
OPENING AND CLOSING THE
LUGGAGE COMPARTMENT
If the Jaguar Smart Key is inadvertently left
inside the luggage compartment and the
vehicle is locked and the alarm set, an audible
warning will sound and the luggage
compartment will re-open after three seconds.
Note: If the Jaguar Smart Key is inside a metal
box, it will not be detected by the vehicle
security system.
The luggage compartment can be opened
using the appropriate button on the Jaguar
Smart Key or via keyless entry. It can also be
opened using the exterior release, provided the
doors are unlocked and the gear selector is in
Park (P).
Provided the vehicle is not locked or alarmed,
the luggage compartment can also be opened
using the interior release button. See 216,
DRIVER CONTROLS.
To close the luggage compartment, press the
button on the closing edge of the luggage
compartment lid.
Note: If any of the luggage compartment
release/close buttons are pressed while the lid
is closing, movement will stop. Check that
there are no obstructions and press the close
button again.
Object detection: If any object is detected, that
would interfere with the luggage compartment
closing, lid movement will stop and reverse a
short distance. Remove any obstructions and
press the close button again.
LUGGAGE COMPARTMENT OPENING
HEIGHT
It is possible to set the maximum height to
which the luggage compartment lid will open.
This is useful in parking areas with very low
roofs or just for ease of use.
Open the luggage compartment lid to the
position which you want to set as the
maximum height.
Press and hold (for 10 seconds) the
luggage compartment close button.
Close the luggage compartment, then open
again to check that it opens to the
programmed height.
The maximum opening height is now set.
To reset the maximum opening height to full,
repeat the process, but fully open the luggage
compartment lid before pressing and holding
the button.