Filter
Top Products
R
(FM8) SEMCON JLR OWNER GUIDE VER 1.00 NAS
LANGUAGE: english-NAS-en; MARQUE: jaguar; MODEL: XJ
Garage door opener
55
REPROGRAMMING A SINGLE
GARAGE DOOR OPENER BUTTON
To program a device to a previously trained
button:
1. Press and hold the desired
pre-programmed garage door opener
button for at least 20 seconds, but no
longer than 30 seconds, until the indicator
lamp begins to flash.
2. Without releasing the rear-view mirror
button, position the hand-held transmitter
approximately 2 to 6 inches (50 to 150
mm) away from the transceiver in the
rear-view mirror, keeping the indicator
lamp in view.
3. Carry out Step 3 of Programming.
ENTRY GATE/CANADIAN
PROGRAMMING
The technology of some entry gates requires
you to press and re-press (cycle) the hand-held
transmitter button every two seconds during
programming.
Continue to press and hold the desired
rear-view mirror button while you cycle your
hand-held transmitter until the indicator lamp
flashes rapidly.
INFORMATION AND ASSISTANCE
For security purposes, it is recommended that
all programmed transceiver buttons are erased
before the vehicle is sold or disposed of.
For information on the range of available
compatible products or accessories, or for
assistance, you should contact your
Dealer/Authorized Repairer.
If you would like additional information on the
Homelink Universal Transceiver, compatible
products or to purchase other accessories,
contact your Dealer/Authorized Repairer or you
can also contact the Homelink helpline on
1-800-355-3515 or on the at
www.homelink.jci.com.
Note: Keep the original transmitter for future
use or programming procedures if, for
example, you purchase a new vehicle.
Note: The manufacturer is not responsible for
any radio or TV interference caused by
unauthorized modifications to this equipment.
Such modifications could void the user’s
authority to operate the equipment.