Filter
Top Products
Quest
®
2 Owner’s Manual 5
GettInG started > turnInG the Quest 2 on and off
Turning the Quest 2 On and Off
Press and hold the Power key on the front of the unit to turn
it on or off. When turned on, the Welcome page appears briefly,
followed by a Safe Driving Warning Message. Press the OK key
to acknowledge the message. Your Quest 2 automatically starts
searching for satellite signals to nd your current location. The rst
time the Quest 2 acquires satellites it may take several minutes.
Afterward, acquisition times are quicker during normal use.
NOTE: If the unit prompts you to enter a security code, contact
your Toyota dealer.
If your unit is in the vehicle mount, it turns on automatically when
you start your vehicle. When you turn off your vehicle, the External
Power Lost message appears. Press any key to switch the unit to
battery power. Otherwise, the Quest 2 turns off after 30 seconds.
Turning Off Satellite Reception for Indoor Use
You can set your Quest 2 to indoor use, which stops satellite
reception and conserves battery power. Thoroughly familiarize
yourself with the routing features of the Quest 2 by
simulating routes.
To turn off satellite reception:
1. Press the Page key to open the Map page.
2. Press the MENU key.
3. Highlight Use Indoors and press OK. GPS is disabled.
To turn on satellite reception:
1. Press the Page key to open the Map page.
2. Press the MENU key.
3. Highlight Acquire Satellites and press OK. GPS is
enabled, and your Quest 2 begins to acquire satellite
signals.