Filter
Top Products
39
Using Track Logs
The eTrex Venture draws an electronic bread crumb
trail on the Map Page as you travel along. This bread
crumb trail is the ‘ Track Log’. The Track Log contains
information about points along its path, including time,
and position. The eTrex Venture uses this information to
allow you to navigate using the saved track.
The ‘ TracBack’ feature allows you to return along a
traveled path without marking any waypoints. When you
are ready to return to where you started, the eTrex Ven-
ture takes you back by following the ‘Track Log’ that you
left behind. You can save a total of ten tracks in the unit
memory. The Track Log starts recording as soon as the
unit gets a satellite location fi x and the Track Log feature
is turned on. When you no longer need a Track Log you
can press the on-screen ‘Clear’ button to remove it.
If you want to keep a record of a certain track log
or use the ‘TracBack’ feature, clear the Track Log before
you start traveling. The percentage of memory used by
the current track log displays at the top of the page. After
the Track Log is ‘Cleared’, it displays zero percent. When
the last track point (bread crumb) is dropped, the most
recent track points start to overwrite the least recent if the
default setting ‘Wrap When Full’ remains selected on the
track log setup. If it is not selected, after the last bread
crumb is dropped, the Track Log stops. To avoid losing
track points, save the Track Log when it approaches the
99% mark.
The Saved Track Page displays the track and it also
can be displayed on the Main Map Page as you navigate.
The ‘TracBack’ feature allows you to retrace your
track in both directions. Tracks are marked BEGIN and
END.
The Recording Method allows you to control how
often the track points (bread crumb) are dropped. It is
based on Distance (from 0 to 9.99 miles), Time (up to 99
hours, 59 minutes, and 59 seconds), or Automatic (More
Often, Normal, Less Often, or Least Often).
Use the Options Menu to delete all saved tracks.
Main Menu
Tracks
Track on Main Map Page
For effective use of the
“TracBack” feature, clear the
Track Log before starting a
new trip or after saving the
Track Log.
Rename saved Track Logs to
help indentify them later.
Tracks Page
190-00203-00_0D.indd 39 12/12/2002, 2:58:32 PM