Furuno GD-1920C-BB Radar Detector User Manual


 
7. CUSTOMIZING YOUR UNIT
7-23
5. Rotate the ENTER knob to select a main screen, then press the ENTER knob. For
example, select the radar display. Your choice is then shaded to show that is has been
selected.
Sub screen
HOT PAGE 1
RADAR
PLOTTER
SOUNDER
COMPASS HIGHWAY EXTVIDEO
Hot page setup menu, SPLIT X 3 screen, sub screen selection
6. Rotate the ENTER knob to select the screen to show at the top right 1/4 screen, then
press the ENTER knob or the C: ENTER soft key.
7. Rotate the ENTER knob to select the screen to show at the bottom right 1/4 screen,
then press ENTER knob or the C: ENTER soft key.
Note: The A: SELECT WINDOW soft key functions to select the window to process.
8. Press the MENU key to close the menu.
7.7 Navigator Setup
This section provides the information necessary for selecting the type of navigator
connected to your plotter.
7.7.1 Navigation data source
The NAV SETUP menu mainly selects the
source of nav data. For GPS receiver other than
the GP-310B/320B, speed averaging and local
time offset (to use local time) are also available.
Press the MENU key followed by the E: SYSTEM
CONFIGURATION, B: NAV OPTION and A: NAV
SOURCE SETTINGS soft keys to display this
menu.
POSITION SOURCE ALL
SPEED SOURCE ETR
TEMPERATURE SOURCE ETR
DE`PTH SOURCE ETR
STW CALIBRATION 0%
TEMP CALIBRATION +0.0
°
F
DEPTH CALIBRATION +0.0ft
WIND AVERAGING 5 minutes
WIND DIRECTION OFFSET P0.0
°
WIND SPEED CALIBRATION 00
°
F