Filter
Top Products
6. DATA TRANSFER
6-1
6. DATA TRANSFER
This chapter provides information for saving and replaying data to and from memory cards,
and receiving and outputting data through the network.
6.1 Memory Card Operations
The memory cards store these data: marks, lines, waypoints, routes, track, position, water
temperature and setting data (plotter only). The following memory cards may be used:
Kingstone: SD-M64B1 (64 MB), SD-M128B1 (128 MB)
Viking: 32SD-M32B1 (32 MB), 64SD-M64B1 (64 MB)
EP Memory: 32 MB, 64 MB
SANDISK: 64SDSDB-64-J60 (64 MB), 128SDSDB-128-J60 (128 MB)
Panasonic: 64 RP-SD064BL1A (64 MB), 128RP-SD128BL1A (128 MB)
Toshiba: 64 SD-NAD064MT (64 MB), 128 SD-NA128MT (128 MB)
6.1.1 Deleting all data (other than chart data) from memory cards
Follow the procedure below to delete all data (other than chart data) from memory cards.
1. Insert a blank memory card into the card slot.
2. Press the MENU key followed by the E: SYSTEM CONFIGURATION, D: DATA
TRANSFER, A: SAVE/LOAD DATA and C: SAVE DATA TO MEMORY CARD soft keys
to show the SAVE DATA menu.
SAVE
DATA
▲
TRACKS OFF
MARKS & LINES OFF
WAYPOINTS & ROUTES OFF
SETTING DATA* OFF
* = Plotter data only
SAVEB
RETURNE
EDITA
DELETED
Save data menu
3. Press the D: DELETE soft key. You are asked if you are ready to delete the contents of
the memory card.
4. Push the ENTER knob to format (or press the CLEAR key to escape). “NOW
DELETING MEMORY CARD” appears. Do not remove the card while its contents are
being deleted. When the formatting is completed, “DELETE COMPLETED. PUSH
ENTER KNOB TO CONTINUE.” appears.
5. Push the ENTER knob to continue.