Furuno GD-1920C-BB Radar Detector User Manual


 
7-1
7. CUSTOMIZING YOUR UNIT
This chapter describes the various options which allow you to set up your unit to suit your
needs. For mode-specific menus, e.g. radar, plotter and sounder, make sure that you select
the appropriate display when making changes or viewing menu options.
7.1 General Setup
This paragraph shows you how to set up functions common to the plotter, radar and
sounder displays. This is done on the GENERAL SETUP menu, which you may display
from any mode. These items include language, key beep, units of measurement, data
sources, etc.
1. Press the MENU key to display the main menu.
2. Press the E: SYSTEM CONFIGURATION soft key.
3. Press the A: GENERAL SETUP soft key.
GENERAL
SETUP1
GENERAL
SETUP2
Page 1
Page 2
KEY BEEP ON
LANGUAGE ENGLISH
RANGE UNIT nm, kt
TEMPERATURE UNIT
°
F
DEPTH UNIT ft
WIND UNIT ft
WIND DATA APPARENT
SPEED AVERAGING 60 seconds
LOCAL TIME OFFSET 9H 0m
RESET TRIP LOG NO
TIMEOUT DISPLAY SETTING 15 sec
SAVE MOB KEY FUNCTION SAVE SHIP
POSITION & MOB
WALLPAPER DEFAULT
LAT/LON DISPLAY DD˚MM.MMMM'
TD DISPLAY LORAN C
SPEED SOG
POSITION DISPLAY LAT/LON
TIME DISPLAY 24 HOURS
RANGE & BEARING MODE RHUMB LINE
BEARING READOUT MAGNETIC
MAGNETIC VARIATION AUTO 07.0
°
E
EDITA
RETURNE
NEXT
PAGE
D
AIS
OPTION
C
EDITA
PREV.
PAGE
E
DST
ON/OFF
B
General setup menu
4. Press the D: NEXT PAGE or E: PREV. PAGE soft key to switch pages if necessary.
5. Use the Trackball to select item.
6. Press the A: EDIT soft key.
7. Use the Trackball to select option desired, then press the C: ENTER soft key.
8. Press the MENU key to close the menu.