Filter
Top Products
AP-4
Activating the Auto plotter
To activate the Auto Plotter, follow the steps
shown below:
1. Adjust the GAIN, A/C SEA and A/C RAIN
controls for proper radar picture.
2. Press the [MENU] key to open the main
menu.
3. Operate the omnipad to select "ARP-10
MENU".
4. Press the [ACQ/ENTER] key. The menu
shown in Figure AP-1 appears.
[ ARP MENU ]
Select item by omnipad
and press ENTER key.
¡. Display
2 . All Cancel
3 . Vector Ref
4 . Vector Length
5 . History
6 . CPA Set
7 . TCPA Set
8 . Auto ACQ
1M
30M
1M
2nm
3M
12M
Off
Rel
3M 6M
Off 15S
2M 3M Off
Off 0.5
3nm 5nm
30S 1M
4M 5M
Off
On
True
30S
15M
30SLo
6M
1nm
6nm
2M
6M
On
Figure AP-1 ARP Menu
5. Operate the omnipad to select the menu
item "1. Display".
6. Operate the omnipad to select "On".
7. Press the [ACQ/ENTER] key.
8. Press the [MENU] key to close the menu.
HDG 234.5°
SP
HU
8
NM
2
TRAIL
30M
ZOOM
ES1
AUTO
25:38
G (OUT)
VRM
0.048NM
0.100NM
13.5 R°
0.142NM
A/C
AUTO
EBL
345.6 R
23.0 R
°
°
TRUE VECTOR
15 MIN
BEARING 42.5°T
RANGE 5.36 NM
CPA 2 NM
COURSE 287.8°T
SPEED 12.5 KT
TCPA 12:35
ARP Data Area
Target under auto tracking but not
selected for cursor data reading
Target selected
for data reading
Auto
Acquisition
Area
Threatening
target
Lost Target
AUTO TARGET
FULL
Target Full
Mark
Figure AP-2 ARP Display