Filter
Top Products
27
10. Attach the EMC core supplied as shown
below.
J806
J805
J803
J804
J802
J801
Motor
J613
J611
J1
EMC core
E04SS251512
(Above cable
clamping
plate)
Cable
entrance
IF9214
PTU-9335
MD9208
Cable
clamping
plate
Figure 6-8 How to attach EMC core
11. Fix the shield cover. Do not pinch the
cable.
12. Attach the radome cover, aligning triangle
mark on radome cover with that on ra-
dome base.
Radome cover
Radome base
Figure 6-9 How to position the radome
cover
13. Loosely fasten the radome fixing bolts.
You will tighten them after confirming
magnetron heater voltage.
Mounting (Model 1932, 1942)
Figure 6-10 Typical antenna unit mounting
locations
1. Drill four fixing bolt holes (13 millimeters
dia.), one cable entry hole (approx. 50 mil-
limeters dia.) in the mounting platform. See
the outline drawing.
6. Remove the cable clamping plate by un-
fastening four screws and removing a gas-
ket.
Shield cover
Shield cover
Pan head
screws
M4x8 7 pcs.
Pan head
screws
M4x8 7 pcs.
Pan head screws
M4x8 4 pcs.
Gasket
Cable clamping plate
Figure 6-5 Antenna unit, inside view
7. Pass the cable through the hole at the bot-
tom of the radome base.
8. Secure the cable with the cable clamping
plate and gasket. Ground the shield and
vinyl wire by one of the screws of the cable
clamping plate.
9. Connect the wire to the RF unit.
to one of the screws
of the cable clamping plate
9-pin connector:
to J801 on MD-9208
4-pin connector:
to J802 on MD-9208
13-pin connector:
to J611 on IF-9214
Figure 6-6 Signal cable, antenna unit side
J802
J801
J611
MD-9208
IF-9214
PTU-9335
Cable
entry
Figure 6-7 RF unit