Filter
Top Products
18
3.10 OTHER MENU Description
The following summarizes the OTHER MENU.
Table 3-2 OTHER MENU Description
Item Description
1. Panel Dimmer Select level of panel backlight.
2. Mark Brill Select brilliance of VRM, EBL, cursor, guard zone and WP marks.
3. HD Mark Select brilliance of heading mark.
4. Charactors Select brilliance of charactors.
5. Trail Tone Select brilliance of echo trails.
6. Int Reject Select level of interference rejection.
7. Pulselength Select pulselength for 1.5 and 3 mile ranges.
8. Noise Reject Select “On” to reject noise.
9. Trail Time Select the trail time.
10. Tune Select automatic or manual tuning.
To tune manually;
1.
2.
3.
4.
Select “Menu” by the omnipad.
Press the [ENTER] key to enable manual tuning.
While pressing and holding down the [GAIN] control, operate
the omnipad.
Press the [ENTER] key.
“MANUAL” appears at the top right-hand corner when manual
tuning is in effect.
11. Disp Data Select the down sourse to display.
12. WPT Mark Select “On” to display the waypoint mark.
13. EBL Ref select EBL reference for relative or true.
14. VRM Unit Select distance unit of VRM and cursor for nm, km or sm.
15. Watchman Turn watchman on (set rest period) or off.
16. STBY Disp Select the display on stand-by; display “STBY” or navigation data,
or go into the economy mode.
17. Guard Mode Select condition which triggers guard alarm; in or out.
18. Own Position Display the cursor position in strength whitch trigger guard alarm.
19. Cursor Posi Dispalay the cursor position in range/bearing or lat/long.
20. Alm sense LV Select minimau echo strength which triggers guard alarm.
21. Dead Sector Select “On” to display the dead sector.
22. Range Select ranges in use.
23. Self Test Test keys, ROM and RAM, check antenna rotation speed, and
display program no.
24. Installation Setup Go to the installation setup menu.