Filter
Top Products
GENERAL OPERATION
PATS SYSTEM - PROBE ONLY
The PATS system fitted to the Probe is unlike the other systems. The
main difference is the system cannot be diagnosed with the FDS2000
or the AD PROGRAMMING SYSTEM. Additional keys and re-
programming of new keys are performed in a different procedure as
well.
PROGRAMMING NEW/ADDITIONAL KEYS (2 or more keys
available)
1. Using one of the existing keys (This becomes KEY 1), insert into
ignition switch.
NOTE : When requested to turn the key ON or OFF, the time
should not be less than 1 Second or more than 2 Seconds between
operations. Unless stated otherwise.
2. Turn the Key to IGNITION ON and then OFF five times, stopping
at the OFF position.
NOTE : PATS LED Should remain ON with the key in the OFF
position.
3. Turn the IGNITION ON using KEY 1., within 15 seconds of step 2.
4.. Turn the IGNITION OFF and remove KEY 1.
5. Insert KEY 2 within 60 seconds of PATS LED illuminating.
6. Turn IGNITION ON and start engine with KEY 2. PATS LED will
extinguish after 1-2 seconds and engine remain running if key is
accepted.
7. Turn IGNITION OFF and remove KEY 2.
8. Insert KEY 3 within 15 seconds of removing KEY 2.
9. Turn IGNITION ON and start engine with KEY 3. PATS LED will
extinguish after 1-2 seconds and engine remain running if key is
accepted.
10. Turn IGNITION OFF and remove KEY 3. Repeat as necessary for
additional keys.
PROGRAMMING NEW/ADDITIONAL KEYS (No keys available)
Programming new key(s) when no keys are available can only be
completed by a FORD dealer.
9