Ford 9 Automobile User Manual


 
REMOTE CONTROL PROGRAMMING
Fiesta 96> & Escort 98> (Radio 3 Button)
Procedure
1. Insert Key and turn to II, then Turn Key from II to I and back to II four times within 3 sec-
onds
2. The PATS LED should light. Turn Key to Position 0.
3. Press the Unlock button and keep it pressed until the PATS LED flashes 4 times.
4. Add additional fobs the same way. Turn to II and back to 0 to end.
Focus (Radio 3 Button)
Procedure
1. Switch Ignition On/Off (II/0) 4 times within 6 seconds until a sound is made.
2. Press any button on Remote until a sound is made.
3. To program additional Remotes, repeat after 2 seconds after the sound.
4. Turn Ignition On/Off to exit.
5. A maximum of 4 remotes can be programmed.
Mondeo 96> Scorpio > 98 (Radio 2 Button)
Procedure
1. Turn Ignition to II, then turn ignition from II to I and back 4 times within 3 seconds.
2. The PATS LED on dash should light.
3. Turn Ignition to 0. Then press Unlock button and keep it pressed until the PATS LED
flashes 4 times (new fob first, then old)
4. Turn Ignition to II, then back to 0 to end.
Transit (2000.5MY)
Procedure
1. Close all the doors.
2. Turn Ignition key from position 0 to II eight times within 10 seconds.
3. Make sure the vehicle locks and unlocks the doors.
4. Press the remote transmitter button within 20 seconds., and make sure the vehicle locks
and unlocks all the doors.
5. Up to 20 seconds is allowed to programme the next remote transmitter.
6. To programme additional remote transmitters, repeat steps 4 and 5.
7. Turn the ignition key to position 0 to exit the programming mode.
Note : Maximum 4 remote transmitters may be programmed.
Note : . Ensure the vehicle battery is fully charged and the anti-theft alarm system is not
armed or triggered.
Note : If programming ends with no new remote transmitters, the originals are retained.
Note : The anti-theft alarm and double locking module will exit programming mode automati-
cally if four new remote transmitters have been programmed or if no new remote transmit-
ters been programmed within the 20 second programming mode.
9