Filter
Top Products
SPECIAL FUNCTIONS
CLEARING PATS 3 SYSTEM (PETROL & DIESEL ENGINES)
CLEAR PATS 3 KEY
GAINING ACCESS
TIME ELAPSED 0:50
TIME REQUIRED 10:00
ACCESS STATUS
IN PROGRESS
BACK TO ABORT
CLEAR PATS 3 SYSTEM
MIN KEYS REQUIRED : 2
TIMED ACCESS
CLEAR TIME 10:00
KEYS PROGRAMMED : 2
PRESS ENTER KEY
Follow the screen instructions to clear
the PATS system.
The TESTER will now start to clear the
PATS
system key codes from memory.
NOTE : If ACCESS STATUS IN PRO-
GRESS is not displayed this indicates
the incorrect system has been selected.
After clearing, the PATS system will
automatically read the key in the
ignition.
Follow on screen instruction to program
the keys.
After programming, disconnect TESTER
leave vehicle for 1 minute and then in-
sert both keys and switch IGNITION ON
to exit programming mode.
After 2 minutes try starting with both
keys.
NOTE : If an error is made, leave the
ignition on for 20 seconds, and then in-
sert both keys and turn ignition ON.
Then try starting again.
NOTE : If the Diagnostic session is
called before the other systems are not
allowed to settle, ie. The dashboard to
finish all the relevant checks are made
the counter will show 0.00 and access
denied or coded access.
9