Filter
Top Products
REMOTE CONTROL PROGRAMMING
Scorpio 95> (Radio 3 Button)
1. Turn Ignition 4 times from 0 to I, ending at position I. An audible tone should be heard
2. Press the Remote Unlock button – there should be another audible tone
3. If more than one Remote then Step 2 should be repeated for each remote in turn, within
ten seconds of each other.
To End turn Ignition to 0 – there should be another audible tone.
Galaxy (Radio 2 button)
1. Make sure all doors and windows are closed.
2. Turn the key in the drivers door lock, 3 times to the unlock position for at least half a sec-
ond and within a total of 5 seconds.
3. The system should now enter programming mode, this is shown by the LED illuminating
continuously for the next 15 secs- during which the key should be programmed as fol-
lows.
4. Press one of the buttons on the key and whilst holding it pressed, simultaneously press
the other button 3 times.
5. Release both buttons.
The key should now flash 5 times and the LED in the door should also flash, six times.
Additional Information
A maximum of four keyless entry remote transmitters can be programmed to the central se-
curity module (CSM). Programming must be done at the same time for all the transmitters.
Note:To enter programming mode, make sure that the vehicle battery is fully charged and
the anti-theft system is not armed or triggered (if equipped).
1. Close all doors and fasten the safety belts to make sure conflicting chimes do not sound
during programming.
2. Turn the ignition switch from position I to position II at least four times in six seconds.
3. Turn the ignition switch to position I.
4. The CSM is now in the learning mode.
5. Press and hold one of the buttons on the remote transmitter until a chime sounds. This in-
dicates a new transmitter code has successfully received.
6. After each successful programming is completed, another 10 second learning mode is
automatically entered, up to a maximum of four times.
7. To program additional transmitters, repeat from step 5.
8. The system will leave the learning mode after the ignition switch is turned to position III, or
if no new transmitter is programmed during the 10 seconds, or if four remote transmitters
have been programmed.
Note:An incorrect programming procedure does not effect the stored codes.
9. After successful programming, only the new programmed transmitters will be accepted.
10. Test all the programmed transmitters, by activating and deactivating the locking/
unlocking functions.
9