Filter
Top Products
GENERAL OPERATION
KEY OPERATION - 98¼ MY ONWARDS
The newer systems are only supplied with 2 keys. Both keys are
required to program further slave keys. Up to a maximum of 8 keys
can be programmed to this PATS system.
KEY PROGRAMMING - UP TO 98 ¼ MY
NOTE : Clear ALL Fault codes before programming.
A new master key can only be programmed using the FDS2000 or
the AD PROGRAMMING systems. Further slaves can be added
without any specialist equipment as follows :-
1. Insert master key, and turn to Position 2. PATS LED should
illuminate.
2. Turn ignition from Position 2 to Position 0, and remove key. PATS
LED will illuminate for 2 seconds. PATS system is now in
programming mode for 10 seconds.
3. Insert the new slave key, and turn from Position 0 to Position 2.
PATS LED will flash once if successful.
4. Repeat for all new slave keys.
NOTE : The Immobiliser receiver does not need reprogramming
when replaced.
9