Filter
Top Products
GENERAL OPERATION
KEY PROGRAMMING - 98¼ MY ONWARDS
NOTE : Clear ALL Fault codes before programming.
Master keys can only be programmed using the 2 PATS keys (A and
B) the FDS2000 or the AD PROGRAMMING SYSTEM system.
NOTE : In some cases the vehicle doors must be closed to perform
the re-programming sequence.
Further slaves can be added without any specialist equipment as
follows :-
1. Insert key A, and turn to Position 2.
2. Turn back to Position 0, and remove key A.
3. Insert key B, and turn to Position 2.
4. Turn back to Position 0, and remove key B.
5. Insert the new slave key and turn to Position 2.
6. Remove new key. Key is now programmed.
7. Procedure can be repeated after 20 seconds, for up to 8 slave
keys.
NOTE : If programming is unsuccessful, the PATS LED will flash
when the key is inserted.
PATS LED INDICATOR
The LED indicator is used for the PATS system and also other Anti-
theft systems fitted to the Ford vehicle range. When the ignition is
switched ON, the PATS LED will illuminate for 3 seconds while it
performs a self-test, after which it extuingishes. When the PATS
system is armed and immobilised the vehicle, the PATS LED will flash
quickly.
If there is a fault on the PATS system, and the engine can start, the
PATS LED will illuminate for 60 seconds continuously, and then flash
the PATS fault code 10 times. If the engine is unable to start and
disabled by the PATS system, then the PATS LED will FLASH for 60
seconds and then flash the PATS fault code 10 times. PATS LED is
mounted either in the front headlining or next to the heater controls/
clock.
9