Filter
Top Products
REMOTE CONTROL PROGRAMMING
Focus Built from 12.2000 Onwards
Note:The ignition must be turned off before attempting to reprogram the key fob.
11. The unlocking mode can be changed by pressing the locking and unlocking buttons on
the remote transmitter simultaneously for a minimum of four seconds.
12. The change is indicated by the turn signal lamps flashing twice.
13. The mode can be carried out as often as required by repeating step 11.
Mondeo 2001 onwards
Note:The ignition must be turned off before attempting to reprogram the key fob.
14. The unlocking mode can be changed by pressing the locking and unlocking buttons on
the remote transmitter simultaneously for a minimum of four seconds.
15. The change is indicated by the turn signal lamps flashing twice.
16. The mode can be carried out as often as required by repeating step 14.
Programming the transmitters.
1. Insert the ignition key and turn it from position II to position 0 and back four times within
three seconds.
2. Remove the ignition key. The module remains in learning mode for 20 seconds and the
anti-theft warning system light stays on continuously.
3. Press one of the transmitter buttons. The signal is learned by the module and indicated by
a flashing anti-theft warning system light. If necessary, repeat the procedure for other trans-
mitters after two seconds.
4. Wait until the module programming is complete, or switch the ignition to ON.
Note:A maximum of four keyless entry remote transmitters can be programmed to the cen-
tral security module. Programming must be done at the same time for all the transmitters.
Note:To enter programming mode, make sure that the vehicle battery is fully charged and
the anti-theft system is not armed or triggered (if equipped).
Note:Close all doors and fasten the safety belts to make sure conflicting chimes do not
sound during programming.
5.Turn the ignition switch from the OFF position to the ON position four times within three
seconds to enter the learning mode. Turn the ignition switch from the OFF position. The
central security module will remain in the learning mode for 20 seconds indicated by the
LED in the instrument panel being illuminated continuously.
6. Press any button on the remote transmitter being programmed. When the signal from the
remote transmitter is accepted by the central security module, the LED will flash.
7. To program additional transmitters, repeat from step 6, with a two second delay after the
LED flashes.
8. To exit the learning mode, turn the ignition switch to the ON position. If no transmitter sig-
nal is received by the central security module for 20 seconds, the system will automatically
exit the learning mode.
9. Test all the programmed transmitters, by activating and deactivating the locking functions.
9