Filter
Top Products
307-01-4 307-01-4Automatic Transaxle/Transmission
ASSEMBLY (Continued)
9. Assemble the manual valve inner lever and
12. CAUTION: Use care not to damage
parking lever actuating rod as shown.
the fluid pan rail surface when installing the
retaining pin.
NOTE: Align the manual control lever shaft
alignment groove with the manual control lever
shaft spring pin bore in the transmission case.
Install the manual control lever shaft spring pin.
• Tap the manual control lever shaft spring
pin into the transmission case.
10. CAUTION: Align the flats on the
manual valve inner lever with the flats on
the manual control lever shaft.
Install the manual control lever shaft.
13. CAUTION: To avoid damage, do not
allow the wrench to strike the manual valve
inner lever pin.
Tighten the nut.
• Tighten to 48 Nm (35 lb-ft).
11. Install the manual valve inner lever onto the
manual shaft and loosely install the nut.
2005 Mustang, 12/2004