Filter
Top Products
307-01-10 307-01-10Automatic Transaxle/Transmission
ASSEMBLY (Continued)
43. NOTE: Align the disc holes on special tool 44. Add dimension B to C, divide by 2 and record
with the slot in gauge bar for correct as dimension D.
measurement.
45. Subtract A from D, and record as dimension E.
Measure the distance from the top of the gauge
bar to the drum bearing surface through the
46. Select bearing from the following chart, using
hole in the disc and record as dimension B.
dimension E.
Repeat measurement 180 degrees opposite side
of the special tool and record as dimension C.
Service Part Number
Dimension E (7D014) Bearing Thickness Identification (Notches)
1.69-1.87 mm XW4Z-CA 2.65-2.80 mm None
(0.066-0.074 in) (0.104-0.110 in)
1.88-2.04 mm XW4X-DA 2.83-2.98 mm One
(0.073-0.080 in) (0.111-0.116 in)
2.05-2.22 mm XW4Z-EA 3.01-3.16 mm Two
(0.081- 0.088 in) (0.118-0.124 in)
2.23-2.43 mm XW4Z-FA 3.21-3.36 mm Three
(0.088-0.096 in) (0.126-0.132 in)
47. NOTE: Make sure that the intermediate band
apply strut is aligned with the band notch.
NOTE: If the intermediate band is reused, it
must be installed in the same position as when
removed.
NOTE: The new intermediate band is dark in
color. This is a normal condition of the band.
Hairline cracks in the band are also considered
normal. Do not install a new band based solely
on the color.
Install the intermediate band.
2005 Mustang, 12/2004