Filter
Top Products
307-01-24 307-01-24Automatic Transaxle/Transmission
ASSEMBLY (Continued)
112. Using the special tool, make sure that the fluid
110. CAUTION: Tightening one screw
pump gear seal ring is fully seated.
before tightening the other may cause the
sensor to bind or become damaged.
NOTE: The manual lever must be in the
NEUTRAL position.
Using the special tool, align the digital TR
sensor and tighten the screws in an alternating
sequence.
• Tighten 10 Nm (89 lb-in).
113. Remove the special tool.
111. CAUTION: The splines of the input
shaft are not the same length on both ends.
The shaft end with the shorter splines goes
into the fluid pump.
Install the input shaft.
2005 Mustang, 12/2004