Filter
Top Products
© 2006 Directed Electronics—all rights reserved 51
and rearmed, and still allow NPC to bypass a faulty zone.
When disarming the system, 5 chirps indicate NPC is activated. The LED will report the zone that has been
bypassed. (See Diagnostics section of this guide.)
valet mode
To enter or exit valet mode with the valet/program switch:
1. Turn the ignition key on and then off.
2. At anytime during the next 10 seconds, press and release the Valet switch. Now the Status
LED will light constantly if you have entered Valet® Mode, and go out if you have exited
Valet Mode.
To enter or exit Valet mode with the transmitter:
To enter or exit Valet Mode with a transmitter:
1. Open any door.
2. Press on the transmitter.
3. Press .
4. Press again. You have now entered or exited Valet Mode (verify by checking your status LED).
rear defogger control
The rear defogger output can be remotely turned on/off any time using the remote control. The default setting
is ON.
To turn the rear defogger output OFF:
1. Press & release the and and buttons of the remote control.
2. The parking lights will flash 2-times.
3. The rear defogger output will no longer activate when the vehicle is remote started.
NOTE: If the remote start is On the lights will turn off then flash 2-times before returning to their
normal output and the defogger output, if active, will cease.