© 2006 Directed Electronics—all rights reserved 23
This wire sends a negative pulse every time the remote start is activated or the doors are unlocked. This can be
used to pulse the disarm wire of the vehicle's factory anti-theft device. Use a relay to send a (-) or (+) pulse to
the disarm wire as shown in the following diagrams.
Relay for Negative (-) Disarm Wire Relay for Positive (+) Disarm Wire
relay satellite wire connection guide
The 8 heavy gauge wires coming from the large connector are used to energize high current circuits in the
vehicle. It is crucial that these connections are well-made and capable of handling the current demands. For this
reason, Scotch-Locks, T-taps and other such connectors are strongly discouraged.
Connect this wire to the starter wire in the vehicle. (See Finding the Wires You Need section.)
For anti grind or starter kill attach this wire to the key side of the starter wire for anti grind and for the starter
kill to be active.
Remove the two 30-amp fuses prior to connecting these wires and do not replace them until the satellite has
been plugged into the control module. These wires are the source of current for all the circuits the relay satel-
lite will energize. They must be connected to a high current source. Since the factory supplies (+)12V to the key
switch that is used to operate the motor, it is recommended that these wires be connected there.
NOTE: If the factory supplies two separate (+) 12V feeds to the ignition switch, connect one RED
wire of the satellite to each feed at the switch.
RED (2) (+)12V input for high current outputs
GREEN starter input
PURPLE (+) starter output
H2/6 LIGHT GREEN/BLACK (-) factory disarm