24 © 2006 Directed Electronics—all rights reserved
Connect this wire to the accessory wire in the vehicle which powers the climate control system.
Connect this wire to the ignition wire in the vehicle.
Connect this wire to the second ignition wire in the vehicle. (See Finding the Wires You Need section.)
NOTE: For vehicles that do not have a second ignition wire, this connection is not required.
Connection for high current outputs.
remote start secondary harness (H3) wire
connection guide
Connect this wire to the provided toggle (override) switch as shown in figure A. Connect the other wire from the
toggle switch to the PARK/NEUTRAL switch in the vehicle. This wire will test with ground with the gear selector
either in PARK or NEUTRAL. This will prevent the vehicle from accidentally being started while in a drive gear.
This input MUST rest at ground in order for the remote start system to operate. Connected properly the vehicle
will only start while in PARK or NEUTRAL.
In some vehicles, the PARK/NEUTRAL position switch activates a factory starter lock out that will not allow the
starter to operate in a drive gear. In these vehicles, connect this wire to the toggle switch as shown in figure B.
Connect the other wire from the toggle switch to chassis ground.
IMPORTANT! Always perform the Safety Check section of this installation guide to verify that the
vehicle cannot be started in ANY drive gear and that the override switch is functioning properly.
H3/1 BLACK/WHITE neutral safety switch input
RED/WHITE (+) 12V input
PINK/WHITE (+) second ignition output
PINK (+) ignition output
ORANGE (+) accessory output