Filter
Top Products
Programming LCD remote
TO ENTER PROGRAMMING MODE
Press and hold the
button until one long beep is heard. Programming mode to customize the
remote’s response is now entered.
NOTE: If no buttons are pressed within 5-seconds,
programming mode will exit with 2-beeps.
BEEPS/VIBRATION ON/OFF
Press to select beeps/vibration On/Off. Beeps alone, or vibration alone, or beeps and
vibration, or no beeps or vibration can be selected. Refer to the table below for these settings.
Beep/Vibrate settings Programming response Icon display*
Beeps only (default) 1-beep Siren icon On
Vibrate only 1-vibrate Vibrate icon On
Beep & Vibrate 1-beep and 1-vibrate Vibrate and siren icon On
No Beep and No Vibrate 1 long beep Vibrate and siren icons Off
*NOTE: This is icon display during programming..
ILLUMINATION ON/OFF
Press to select LCD backlight illumination On/Off.
The LCD backlight will illuminate when a remote
button is pressed, or a alarm status page is received.
LCD Backlight settings Programming response
ON
1-beep, backlight ON
OFF
2-beeps, backlight OFF
6 © 2006 Astroflex Electronics - All rights reserved