Filter
Top Products
QUICK REFERENCE GUIDE
To arm using your remote
You can activate, or arm, the system by pressing
on your remote for one second. When
the system arms, you will hear a short siren sound, or chirp, and the parking lights will flash
once. If the vehicle’s power door locks have been connected to the system, the doors will
lock.
To disarm using your remote
To disarm the system, press
. You will hear two chirps, and the parking lights will flash
twice. If power locks are connected to the system, the doors will unlock. If the siren chirps
either four or five times when disarming, see Diagnostics section. This is called Tamper Alert.
Arming while driving
Press
on your remote for two second while the vehicle is running. The system will chirp
once and then once more to indicate that the ignition is on.
Disarming without a remote
Turn on the ignition. Press and release the Valet
®
button the programmed number of times
within 15 seconds. After three seconds, the system will disarm. If it does not, you may have
waited too long. Turn the ignition off and on and try again.
To enter or exit Valet
®
Mode
Turn ignition to RUN position, then turn to OFF position. Press and release the Valet
®
button
within 10 seconds. The in-vehicle status LED will light solid if you are entering Valet
®
Mode,
and it will go out if you are exiting Valet
®
Mode.
Location of Valet Button
Number of Pulses
To activate Panic Mode
Press and hold
down for approximately two seconds or press
or
down for
approximately five seconds.
To exit Panic Mode
Press and hold
,
or
or
down for approximately one seconds.
To activate Silent Mode™
Press
briefly before arming or disarming, and the confirmation chirp(s) will be eliminated
for that one operation only.
27 © 2006 Astroflex Electronics - All rights reserved